Microcontroller Firmware
Firmware architecture, I/O, timing, communication and peripheral integration in C/C++.
Embedded Systems & IoT
From system block diagram to a tested hardware prototype.
Support for microcontroller firmware, sensors, circuit and PCB design, and connected system architecture — scoped around your coursework, assignment or graduation project.
Embedded Support Areas
Four routes from requirement to working prototype.
The scope can cover one layer of the system or the full hardware-and-firmware chain — matched to the assignment and the required academic outputs.
Sensors & Actuators
Signal acquisition, conditioning, control and interface development for real hardware.
Circuit & PCB Design
Schematic, simulation, layout planning and hardware integration for prototype boards.
Connected Systems
Device-to-cloud architecture, data flow and system-level development for IoT projects.
Development Stack
Software on one side, hardware outputs on the other.
The tools follow the course environment — the outputs follow the submission requirements.
Software & Tools
C / C++PythonProteusAltium DesignerMATLAB / SimulinkMicrocontroller IDEs
Typical Outputs
- Firmware source code
- Circuit and PCB files
- System diagrams and I/O maps
- Prototype test procedures
- Technical documentation
System Layers
A clean stack from application down to the board.
Selected Technical Experience
Examples of prototype and PCB capability.
These visuals demonstrate technical experience. Each student project is reviewed and scoped independently.
Door Sensor PCBProteus · PCB Design
Temperature MonitorArduino · Sensors
Raspberry Pi LayoutSingle-Board · IoT
Project images are presented to demonstrate technical capability and do not imply university endorsement or permission to reuse the work as an academic submission.
Where This Fits
Embedded work usually feeds a wider academic deliverable.
Hardware, firmware and testing connect into graduation projects and research workflows.
Embedded Systems & IoT Review
Send your block diagram, circuit files or prototype brief for an initial technical review.
A finished prototype is not required. Sketches, screenshots, code snippets or a partial design are enough to begin.